FINAL INTERNATIONAL ISO/FDIS DRAFT STANDARD 19232-2 IS0/TC135/SC5 Non-destructive testing Image Secretariat: DIN quality of radiographs - Voting begins on: 2013-02-14 Part 2: Voting terminates on: Determination of the image quality 2013-04-14 value using step/hole-type image quality indicators Essais non destructifs- Qualité d'image des radiogrammes - Partie 2: Détermination de la qualité d'image a I'aide d'indicateurs de qualitée d'image a trous et a gradins Please see the administrative notes on page ii RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEYAREAWAREANDTO PROVIDESUPPORTING DOCUMENTATION INADDITIONTOTHEIR EVALUATIONAS Reference number BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO- ISO/FDIS 19232-2:2013(E) LOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON SO OCCASION HAVETO BE CONSIDERED IN THE LIGHT OFTHEIR POTENTIALTO BECOME STAN- DARDS TO WHICH REFERENCE MAY BE MADE IN Copyright International Organization for Standardization NS @IS02013 HS unde from IHS Not for Resale IS0/FDIS 19232-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permitted without license from IHS Not for Resale IS0/FDIS 19232-2:2013(E) ISO/CEN PARALLEL PROCESSING This final draft has been developed within the European Committee for Standardization (CEN), and processed under the CEN-lead mode of collaboration as defined in the Vienna Agreement. The final draft was established on the basis of comments received during a parallel enquiry on the draft. This final draft is hereby submitted to the ISO member bodies and to the CEN member bodies for a parallel two- month approval vote in ISO and two month formal vote in CEN. Positive votes shall not be accompanied by comments. Negative votes shall be accompanied by the relevant technical reasons. iii No reproduction or Not for Resale