ISO INTERNATIONAL STANDARD 16333 Second edition 2011-02-15 Heavy commercial vehicles and buses Steady-state rollover threshold Tilt- table test method Véhicules utilitaires lourds et autobus - Seuil statique de renversement - Methode d'essai du plateau incliné Reference number ISO 16333:2011(E) @ ISO 2011 oyIHSunder Not for Resale ISO16333:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISo's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2011 - All rights reserved I without license from IHS Not for Resale ISO 16333:2011(E) Contents Page Foreword IV Introductior 1 Scope 2 Normative references 3 Terms and definitions 4 Principle 5 Variables 6 Measuring equipment 6.1 General... 6.2 Description 6.3 Data processing. 7 Test condition 7.1 General 7.2 Tilt-table properties 7.3 Ambientconditions 7.4 Test vehicle... 8 Test procedure... 8.1 Installation of vehicle on tilt-table 8.2 Test tilts. 6 Data analysis.. 9.1 General.... 9.2 Tilt-table ratio.... 9.3 Optional data presentations. Annex A (normative) Test report Additional test conditions. Annex B (informative) Error sources 13 ii from IHS Not for Resa