ISO INTERNATIONAL STANDARD 9117-6 First edition 2012-06-15 Paints and varnishes Drying tests Part 6: Print-free test Peintures et vernis -Essais de séchage - Partie 6:Essai deséchageapparent complet Reference number ISO 9117-6:2012(E) @ISO2012 ISO 9117-6:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland = @ ISO 2012 -All rights reserved ISO9117-6:2012(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (lSOmemberbodies).TheworkofpreparingInternationalStandardsisnormallycarriedoutthroughso non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 9117-6 was prepared by Technical Committee ISO/TC 35, Paints and varnishes, Subcommittee SC 9 General test methods for paints and varnishes. Iso 9117 consists of the following parts, under the general title Paints and varnishes - Drying tests: Part 1: Determination of through-dry state and through-dry time 一 Part 2: Pressure test for stackability Part 3: Surface-drying test using ballotini Part 4: Test using a mechanical recorder Part 5: Modified Bandow-Wolff test Part 6: Print-free test @ ISO 2012 - All rights reserved ili