ISO INTERNATIONAL STANDARD 13261-1 First edition 1998-04-01 Sound power rating of air-conditioning and air-source heat pump equipment - Part 1: Non-ducted outdoor equipment Détermination du niveau de puissance acoustique des climatiseurs et pompes a chaleur sur I'air Partie 1: Appareils extérieurs non raccordés ISO Reference number ISO 13261-1:1998(E) y IHS under ted without license from IHS Not for Resale ISO 13261-1:1998(E) Contents Page Scope. 2 Normative references.. 3 Definitions. 2 4 4.1 Testing requirements for equipment.. 4.2 Data to be taken. 4.3 Special testing considerations for the optional 63 Hz octave band.. 4.4 Use of windscreen ... 4.5Equipment mounting.... 5 Sound rating procedures.. 5.1 General... 5.2 Determination of equipment sound power levels .... 5 5.3 Determination of the octave band sound power level rating, Lw....... 5 5.4 Determination of the A-weighted overall sound power 6 5.5 Standard rating conditions. 6 Published ratings .. 6.1 General.... 8 6.2 Standard ratings .... 8 6.3 Application ratings ... 8 Annex A: Special rating procedure using Iso 9614 ... 9 Annex B: Determination of the single-number, tone-adjusted A. weighted overall sound power level sound quality indicator (LwAT) 10 @ISO1998 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 · Switzerland Internet [email protected] X.400 C=ch; a=400net; p=iso; 0=isocs; S=central Printed in Switzerland Copyright International Organization for Standardization vided by IHS under se from IHS Not for Resale ISO 13261-1:1998(E) @ ISO Foreword ISO (the International Organization for Standardization) is a worldwide federationofnationalstandardsbodies(lSOmemberbodies).Theworkof preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which on that committee. International organizations, governmental and non- governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 13261-1 was prepared by Technical Committee ISO/TC 86,Refrigeration,SubcommitteeS SC 6,Factory-made air- conditioning and heat pump units Annex A forms an integral part of this part of ISO 13261. Annex B is for information only. ili Copyright International Organization for Standardization ed without license from IHS Not for Resale