International ISO T Standard IS0/ASTM52933 Additive manufacturing First edition Environment, health and safety 2024-03 - Test method for the hazardous substances emitted from material extrusion type 3D printers in the non-industrial places Fabrication additiveEnvironnement, santé et sécuriteé- Méthode d'essai pour les substances dangereuses émises par les imprimantes 3D de type a extrusion de matiere dans les lieux non industriels Referencenumber ISO/ASTM 52933:2024(en) @ISO/ASTM International2024 IS0/ASTM 52933:2024(en) COPYRIGHT PROTECTED DOCUMENT @IS0/ASTMInternational2024 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below orIsO'smemberbodyinthecountryoftherequesterIntheUnitedStates,suchrequestsshouldbesenttoASTMInternational. ISO copyright office ASTM International CP 40i : Ch. de Blandonnet 8 100 Barr Harbor Drive, PO Box C700 CH-1214 Vernier, Geneva West Conshohocken, PA19428-2959,USA Phone:+4122749 0111 Phone: +610 832 9634 Fax: +610 832 9635 Email: [email protected] Email: [email protected] Website: www.iso.org Website: www.astm.org Published in Switzerland @ IS0/ASTM International 2024- All rights reserved ii