ISO INTERNATIONAL STANDARD 10517 Third edition 2019-02 Powered hand-held hedge trimmers Safety Taille-haies portatifs a moteur Sécurité Reference number IS0 10517:2019(E) Tso @IS02019 IS0 10517:2019(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2019 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +41 22 749 01 11 Fax: +41 22 749 09 47 Email: [email protected] Website: www.iso.org Published in Switzerland ii @ IS0 2019 - All rights reserved IS0 10517:2019(E) Contents Page Foreword ..V Introduction. ..vi 1 Scope. 2 Normative references 3 Terms and definitions 4 List of significant hazards 5 Safety requirements and/or verification of safety measures .1 5.1 General. .7 5.2 Handles and cutting device ..7 5.2.1 Handles .7 5.2.2 Hand protection. 5.2.3 Handle strength. .10 5.2.4 Cutting device and blunt extensions .11 5.2.5 Shoulder harness requirements. .15 5.2.6 Holding moment, .15 5.2.7 Blade stopping time .18 5.2.8 Cutting device cover. 20 5.2.9 Cutting device accessories. 20 5.3 Starting and idling. 20 5.4 Controls. 20 5.4.1 Marking 20 5.4.2 Throttle control 20 5.4.3 Engine stop 21 5.5 Power driven parts protection 21 5.6 Heat protection. 21 5.6.1 General 21 5.6.2 Test equipment, test conditions and test method 21 5.6.3 Test acceptance 22 5.7 Fuel tank 22 5.8 Engine exhaust 22 5.9 Electrical requirements of ignition system 23 5.9.1 General 23 5.9.2 Ignition circuit. 23 5.9.3 Test method. 23 5.9.4 Test acceptance 23 5.10 Vibration 23 5.10.1 Reduction by design and protective measures 23 5.10.2 Reduction by information 24 5.10.3 Vibration measurement. 24 5.11 Noise. 24 5.11.1 Reduction by design and by information. 24 5.11.2 Noise emission measurement. .24 6 Information for use. .24 6.1 Instructions for use. 24 6.2 Marking. 25 6.3 Warnings .26 6.4 Test of labels .26 6.4.1 Preparation of test specimens and control specimens .26 6.4.2 Wipe resistance test. .27 6.4.3 Adhesion test .27 Annex A (informative) Safety instructions. .28 @ IS0 2019 - All rights reserved iii