ISO INTERNATIONAL STANDARD 10936-1 Second edition 2017-08 Optics and photonics Operation microscopes - Part 1: Requirements and test methods Optique et photonique-Microscopes chirurgicaux- Partie 1: Exigences et méthodes d'essai Reference number ISO 10936-1:2017(E) iso Intemational Organization for Standardization @ISO2017 =ZHEJIANG INST OF STANDARDIZATION C1 5956617 ensefrom IHS IS010936-1:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS02017,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Intematinaibr PrganizationfoStandardization Licensee-ZHEJIANG INSTOF STANDARDIZARoISQ0,7 - All rights reserved networking permited without license from IHS NotforResale, 2017/9/2705:53:18 IS0 10936-1:2017(E) Contents Page Foreword ..iv 1 Scope. 2 Normative references 3 Termsanddefinitions 4 Requirements .2 4.1 General .2 4.2 Optical and mechanical requirements 2 4.3 Environmentalconditions .2 4.4 Safety 2 5 Test methods. .2 5.1 General 2 5.2 Checking the optical and mechanical specifications .2 5.3 Checkingtheenvironmentalconditions 2 5.4 Checking the safety. .2 6 Marking .2 Bibliography 4 iii See=ZHEJIANG INSTOFSTANDARDIZATION C15956617 withoutlicense from IHS