ISO INTERNATIONAL STANDARD 11484 Third edition 2019-04 Steel products Employer's qualification system for non- destructive testing (NDT) personnel Produits en acierSystemedequalification,parI'employeur du personnel pour essais non destructifs (END) Reference number IS0 11484:2019(E) so @ IS0 2019 IS0 11484:2019(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2019 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +4122 749 0111 Fax: +41 22 749 09 47 Email: [email protected] Website: www.iso.org Published in Switzerland ii @ IS0 2019 - All rights reserved IS0 11484:2019(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ...1 2 Normative references 3 Terms and definitions 4 Responsibilities. 4.1 General .6 4.2 Employer's qualifying body ..7 5 Levels of qualification ..7 5.1 General. .7 5.2 NDT Level 1 1 5.3 NDT Level 2 .7 6 Requirements and procedures for the qualification by employer .8 7 Qualification requirements .8 7.1 General. 7.2 Training ..8 7.3 Industrial NDT experience. 7.4 Vision requirements All levels .10 8 Qualification examination ..11 8.1 General 11 8.2 Examination content. 11 8.2.1 General examination .11 8.2.2 Specific examination. .11 8.2.3 Practical examination .11 8.3 Conduct of the examinations. .12 8.4 Grading .12 8.5 Re-examination. .13 9 Qualification .13 9.1 General. .13 9.2 Content of the qualification record .13 9.3 Digital qualification records. ..14 9.4 Validity .14 9.4.1 General ..14 9.4.2 Re-validation .15 9.5 Renewal. .. 15 10 Re-qualification ..15 11 Files ..15 12 Transition period for examiners ..16 Annex A (normative) Weighting of practical examination ..17 Bibliography .19 IS0 2019 - All rights reserved iii