ISO INTERNATIONAL STANDARD 2074 Second edition 2007-08-01 AMENDMENT 1 2017-07 Plywood Vocabulary AMENDMENT 1 Contreplaqué - Vocabulaire AMENDEMENT1 Reference number IS0 2074:2007/Amd.1:2017(E) ISO @IS02017 IS0 2074:2007/Amd.1:2017(E) COPYRIGHTPROTECTEDDOCUMENT @IS0 2017,Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org ii @ IS0 2017 - All rights reserved IS0 2074:2007/Amd.1:2017(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out throughIsotechnicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with Iso, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the IsO/IEc Directives, Part 1. Inparticular, the different approval criteria needed forthe different types of IsO documents should be noted. This document was drafted in accordance with the editorial rules of the ISO/IEC Directives, Part 2 (see www.iso.org/directives). Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the Iso list of patent declarations received (see www.iso.org/patents). Any trade name used in this document is information given for the convenience of users and does not constituteanendorsement. For an explanation on the voluntary nature of standards, the meaning of Iso specific terms and expressions related to conformity assessment, as well as information about IsO's adherence to the World Trade Organization (WTO) principles in the Technical Barriers to Trade (TBT), see the following URL:www.iso.org/iso/foreword.html This document was prepared by Technical Committee ISo/TC 89, Wood-based panels, Subcommittee SC 3, Plywood. @ IS0 2017 - All rights reserved ii