ISO INTERNATIONAL STANDARD 3867 Third edition 2017-07 Composition cork Expansion joint fillers Test methods Agglomere composéde liege-Materiaupour le remplissagede joints dedilatation-Methodesd'essai Referencenumber IS03867:2017(E) iso Intemational Organization for Standardization @IS02017 e=ZHEJIANG INST OF STANDARDIZATION C15956617 No reproduction or itted without license from IHS IS0 3867:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS02017,Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8.CP 401 CH-1214 Vernier, Geneva, Switzerland Tel.+4122 749 0111 Fax+41227490947 [email protected] www.iso.org Uicensee-ZHEJIANG INST OF STANDARDIZoISQ 3q,7 -All rights reserved networking permited without license from IHS Not for Resale, 2017/9/27 05:51:22 IS0 3867:2017(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Terms and definitions ..1 4 Apparatus ..1 5 Samplingandpreparationoftestspecimens .2 5.1 Sampling .2 5.2 Preparation of test specimens .2 6 Tests. 2 6.1 Determination of dimensions 2 6.1.1 Determination ofthickness 2 6.1.2 Determination of length and width 2 6.2 Expansion in water .3 6.2.1 Procedure 3 6.2.2 Calculation and expression of results .3 6.3 Recovery 3 6.3.1 Procedure. .3 6.3.2 Calculationand expressionof results 3 6.3.3 Retestprovision .4 6.3.4 Calculation of compression .4 6.4 Extrusion.. 4 6.4.1 Procedure. .4 6.4.2 Calculation and expression of results .5 6.5 Waterabsorption .5 6.5.1 Procedure 5 6.5.2 Calculationand expressionof results .5 6.6 Apparentdensity .5 6.6.1 Procedure .5 6.6.2 Calculationandexpressionofresults .6 7 Test report .6 Bibliography 7 iii See=ZHEJIANG INSTOFSTANDARDIZATION C15956617 vithoutlicense from IHS
ISO 3867 2017 Composition cork — Expansion joint fillers — Test methods