ISO INTERNATIONAL STANDARD 3869 Third edition 2017-07 Agglomerated cork - Expansion joint fillers Specifications, packaging and marking Aggloméré composédeliege-Matériaupourleremplissagede joints de dilatation -Spécifications, emballage et marquage Referencenumber IS03869:2017(E) so Intemational Organization for Standardization @IS02017 e=ZHEJIANG INST OF STANDARDIZATION C15956617 Not for Resale, 2017/9/27 05:51:00 itted without license from IHS IS03869:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS02017,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 [email protected] www.iso.org Licensee-ZHEJIANG INST.OF STANDARDIZoISQ0a7 -All rights reserved networking permited without license from IHS Not for Resale, 2017/9/27 05:51:00 No reproduction or r IS03869:2017(E) Contents Page Foreword ..iv 1 Scope. 2 Normativereferences 3 Terms and definitions 4 Characteristics 4.1 Types.... .1 4.2 Materials. 4.3 Dimensions and tolerances .1 4.4 .2 Recovery 4.5 Compression 2 4.6 Extrusion. .2 4.7 Expansion in water. 2 4.8 Apparent density .2 5 Packaging .2 6 Marking. .2 Bibliography ..3 Intematinal oganzation @stS.20.17 - All rights reserved iii See=ZHEJIANG INSTOFSTANDARDIZATION C15956617 d without license from IHS Not for Resale, 2017/9/27 05:51:00