ISO INTERNATIONAL STANDARD 4386-2 Third edition 2019-04 Plain bearings Metallic multilayer plain bearings - Part 2: Destructive testing of bond for bearing metal layer thicknesses greater than or equal to 2 mm Paliers lisses - Paliers lisses métalliques multicouches - Partie 2: Détermination, par essai destructif, de I'adherence du matériau antifriction d'épaisseur supérieure ou égale a 2 mm Reference number ISO 4386-2:2019(E) osi @ IS0 2019 IS0 4386-2:2019(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2019 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or Iso's member body in the country of the requester. ISO copyright office CP 401 : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +41 22 749 01 11 Fax: +41 22 749 09 47 Email: [email protected] Website: www.iso.org Published in Switzerland ii @ IS0 2019 - All rights reserved IS0 4386-2:2019(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ...1 2 Normative references 3 Terms and definitions 4 Principle ..1 5 Test equipment. .2 5.1 General. .2 5.2 Testing apparatus. 6 Specimen .3 6.1 General .3 6.2 Specimen machining sequence 7 Procedure ..5 8 Evaluation. ..6 8.1 General. .6 8.2 Designation .7 8.3 Test report. .7 9 Application for quality control and process qualification .8 9.1 General. .8 9.2 Quality control. ..8 9.3 Process qualification ..8 Bibliography .10 @ IS0 2019 - All rights reserved ii