ISO INTERNATIONAL STANDARD 6301-1 Fourth edition 2017-09 Pneumatic fluid power - Compressed-air lubricators Part 1: Main characteristics to be included in supplier's literature and product- marking requirements Transmissions pneumatiques -Lubrificateurs pour air comprimé- Partie 1: Principales caracteristiques a inclure dans la documentation du fournisseur et exigences de marquage du produit Reference number IS0 6301-1:2017(E) Tso IS02017 IS0 6301-1:2017(E) GetmoreFREEstandardsfromStandardSharingGroupandourchats COPYRIGHT PROTECTED DOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form writtenpermission.PermissioncanberequestedfromeitherIsoattheaddressbeloworIso'smemberbodyinthecountryof the requester. ISO copyright office Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org ii IS02017-Allrightsreserved IS0 6301-1:2017(E) Contents Page Foreword iv Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Technical requirements , 4.1 General characteristics 4.1.1 General dimensions 4.1.2 Port forms. 4.1.3 Rated pressure 4.1.4 Range of operating temperatures 4.2 Particular requirements ... 4.2.1 Pressure drop contingent on air flow rate. 4.2.2 Lubricator type.. 4.2.3 Minimum operating flow rate. 4.2.4 Lubricant reservoir capacity 4.2.5 Adjustmentoflubricantflow 4.2.6 Filling... 4.2.7 Materials of construction 5 5 Operationandmaintenance 6 Marking. 7 Identification statement (reference to this document) .6 Annex A (informative) Thread lengths from Is0 1179-1 Bibliography IS02017-Allrightsreserved iii