ISO/TS TECHNICAL SPECIFICATION 8103-6 First edition 2017-09 Escalators and moving walks - Part 6: Safety parameters meeting the GESRs Escaliers mécaniques et trottoirs roulants - Partie 6: Titre manque Reference number ISO/TS 8103-6:2017(E) ISO @ IS0 2017 IS0/TS 8103-6:2017(E) COPYRIGHTPROTECTEDDOCUMENT @IS0 2017,Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax+4122 74909 47 [email protected] www.iso.org ii @ IS0 2017 - All rights reserved IS0/TS 8103-6:2017(E) Contents Page Foreword .iv Introduction .V 1 Scope .1 2 Normative references .1 3 Terms and definitions 1 4 Development of global safety parameters (GSPs) 4.1 Purpose of GSPs. 4.2 Approach. 5 Understanding and implementing GSPs 7 5.1 Overallobjective 5.2 Properties and use of GSPs 8 5.2.1 GSPs.. 8 5.2.2 Process ofimplementingGSPsl 8 5.2.3 Ways of using GESRs and GSPs 9 5.2.4 Applicability of GESRs and GSPs .9 5.2.5 Safety objectives of GSPs 10 5.3 Use of IS0/TS 25740-1 and this document .15 6 Global safety parameters .15 Annex A (informative) Anthropometric and design data summary .34 Annex B (normative) Figures .36 Bibliography 40 @ IS0 2017 - All rights reserved iii