ISO INTERNATIONAL STANDARD 1268-2 First edition 2001-03-15 Fibre-reinforced plastics Methods of producing test plates - Part 2: Contact and spray-up moulding Plastiques renforcés de fibres - Méthodes de fabrication de plaques d'essai- Partie 2: Moulage au contact et par projection Reference number ISO 1268-2:2001(E) Tso @ ISO 2001 Copyright Intemational Organization for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO 1268-2:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's mem- ber body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland yatigaaiSandardizato @ ISO 2001 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 1268-2:2001(E) Contents Page 1 Scope 2 Normative references 3 Health and safety 4 Principle 5 Materials 2 6 Plate dimensions 2 Reinforcement content 3 8 Apparatus 3 9 Procedure 4 10 Verification of the characteristics of the plate obtained 5 11 Marking 5 12 Test plate preparation report 5 Annex A Estimation of the number of reinforcement layers for various reinforcement materials. 7 A.1Calculation method A.2Product method ili No reproduction or networking permited without license from IHS Not for Resale