ISO INTERNATIONAL STANDARD 128-15 First edition 2013-07-01 Technical product documentation (TPD) General principles of presentation Part 15: Presentation of shipbuilding drawings Documentation technique de produits (TPD) - Principes généraux de representation- Partie 15: Représentation des dessins de construction navale Reference number IS0 128-15:2013(E) LSO @ IS0 2013 I without license from IHS Not for Resale IS0 128-15:2013(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved networking permitted without license from IHS Not for Resale IS0 128-15:2013(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 General principles. 4 Presentation of drawings 4.1 Basic requirements .1 4.2 View... 4.3 Sectional view .3 4.4 Section. 4.5 Partial detailed drawing. .6 4.6 Special drawing methods 4.7 Simplified representation 7 5 Coding and arrangement ..9 5.1 The coding of station, waterline and buttock lines .9 5.2 Coding of frame. .9 5.3 Coding of the outer shell plate. .10 5.4 Coding of stringer. ..10 5.5 Coding of liquid tank and cargo hold .10 6 Graphic symbols. .10 Bibliography .12 iii ded by IHS under license with ISt ed without license from IHS Not for Resale