ISO INTERNATIONAL STANDARD 13400-4 First edition 2016-03-15 Road vehicles Diagnostic communication over Internet Protocol (DoIP) 一 Part 4: Ethernet-based high-speed data link connector Vehicules routiers Communication de diagnostic sur protocole Internet (DoIP) Partie 4: Connecteur de lien de données haut debit fondées sur I'éthernet Reference number IS0 13400-4:2016(E) TSO International Organization for Standardization @ IS0 2016 IS0 13400-4:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Internatinair PrganizationforStandardization icensee-ZHEJIANG INST OF STANDARDIZAoISQ06- All rights reserved etworking permitted without license from IHS IS0 13400-4:2016(E) Contents Page Foreword ..iv Introduction. 1 Scope. ..1 2 Normativereferences 3 Terms, definitions, symbols and abbreviated terms. 3.1 Terms and definitions .2 3.2 Abbreviated terms... .2 4 Conventions .3 5 Connector requirements. .3 5.1 General .3 5.2 Normative references to IS0 15031-3 .3 5.3 Ethernet specific requirements .3 Annex A (normative) Ethernet pin assignment option 1 .4 Annex B (normative) Ethernet pin assignment option 2 .7 Bibliography .10 iii e=ZHEJIANG INSTOFSTANDARDIZATION C15956617 vided by IHS under I ithout license from IHS