ISO INTERNATIONAL STANDARD 13405-1 Second edition 2015-01-15 Prosthetics and orthotics Classification and description of prosthetic components Part 1: Classification of prosthetic components Protheses et ortheses - Classification et description des composants deprotheses- Partie 1: Classification des composants de protheses Reference number IS0 13405-1:2015(E) SO International Organization for Standardization @ IS0 2015 dardization 5956617 ed without license from IHS IS0 13405-1:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/3/11 01:06:15 networking permitted without license from IHS IS0 13405-1:2015(E) Contents Page Foreword ..iv Introduction. 1 Scope. 2 Terms and definitions 3 Classification .2 3.1 General 2 3.2 Interface components .2 3.3 Functional components 23 3.4 Alignment components. 3.5 Structural components (prosthetic construction) 3 3.6 Finishing (cosmetic) components. 3 Inteatinal oganzation @st(Sr20.1.5 - All rights reserved iii see=Zhejiang Institute of Standardization 5956617 vided by IHS underI ed without license from IHS Not for Resale, 2015/3/11 01:06:15