ISO INTERNATIONAL STANDARD 13715 Third edition 2017-03 Technical product documentation - Edges of undefined shape Indication and dimensioning Documentation techniquede produits-Aretes de forme non definie -Indicationetcotation Referencenumber IS013715:2017(E) iso Intemational Organization for Standardization @IS02017 =ZHEJIANG INSTOFSTANDARDIZATIONC15956617 Not for Resale, 2017/5/11 01:57:29 itted without license from IHS IS013715:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS02017,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISo copyright office Ch. de Blandonnet 8.CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 [email protected] www.iso.org Uicensee-ZHEJIANG INSTOF STANDARDIZAoISQl,7 -All rights reserved etworking permitted without license from IHS Not for Resale, 2017/5/11 01:57:29 IS013715:2017(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normative references 3 Terms and definitions 4 Indications on drawings ..4 4.1 Basicindication 4 4.2 Types of undefined edge .5 4.3 Size... .5 4.4 Directionofpassingorundercut 7 4.4.1 Indication in one direction 7 4.4.2 Asvmmetricalindication 8 4.5 Locationofthebasic symbol. .8 4.5.1 General ..8 4.5.2 Individual indication of edges .9 4.5.3 Indication of limited areas. .10 4.5.4 General indication of edges .11 4.5.5 Exceptions from general indications of edges .13 4.6 Referencetothisdocument ..15 Annex A (normative) Proportions and dimensions ofgraphical symbols ..16 AnnexB (informative)Examplesof indicationofundefined edges ..18 Bibliography .22 iii See=ZHEJIANG INSTOFSTANDARDIZATIONC15956617 thout license from IHS