ISO INTERNATIONAL STANDARD 13793 First edition 2001-03-15 Thermal performance of buildings . Thermal design of foundations to avoid frost heave Performance thermique des batiments Conception thermique des fondations pour éviter les poussées dues au gel Reference number ISO 13793:2001(E) ISO @ ISO 2001 py IHS under lic ted without license from IHS Not for Resale ISO13793:2001(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ISO2001-All rightsreserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 13793:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 13793 was prepared by the European Committee for Standardization (CEN) in collaboration with ISO Technical Committee TC 163, Thermal insulation, Subcommittee SC 2, Calculation methods in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). Throughout the text of this standard, read "..this European Standard..." to mean "...this International Standard..". ii