ISO INTERNATIONAL STANDARD 17325-1 Firstedition 2014-06-15 Ships and marine technology Marine environment protection Oil booms - Part 1: Design requirements Navires et technologie maritime-Protection de I'environnement marin-Barragesderétentiondepétrole Partie 1:Exigences de conception Reference number IS017325-1:2014(E) LSO @IS02014 without license from IHS Not for Resale IS017325-1:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 4122 749 0111 Fax +41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014- All rights reserved No reproduction or networking permited without license from IHS Not for Resale IS017325-1:2014(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normativereferences 3 Terms and definitions 4 Boom design .2 4.1 Application .2 4.2 Environmentalconsiderations 2 4.3 Parts of booms.. .2 4.4 Types of booms. .2 5 Boomfunctionsandconfigurations .3 5.1 General .3 5.2 Containment .3 5.3 Deflection. .3 5.4 Protection .3 5.5 Configurations .3 6 Forces on boom assemblies .7 7 Classificationofboomsbyenvironmental conditions ..7 8 Datarequirementsformanufacturers ..8 9 Designation and marking .10 9.1 General ..10 9.2 Marking 10 AnnexA (informative)Forces onboomassemblies-Calculations ..11 Bibliography .13 iii IHS under I thout license from IHS Not for Resale