ISO INTERNATIONAL STANDARD 26623-2 Secondedition 2014-09-01 Polygonal taper interface with flange contact surface - Part 2: Dimensions and designation of receivers Interfaces a cone polygonal avec face d'appui - Partie 2: Dimensions et désignation des nez de broche Reference number IS0 26623-2:2014(E) LSO @ IS0 2014 I without license from IHS Not for Resale IS0 26623-2:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 26623-2:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Dimensions. 3.1 General .1 3.2 Polygon-receivers 1 4 Clamping forces 5 Designation Annex A (informative) Recommendations for use and application ..4 Bibliography .5 Copyriatiteatinal rganiason t? Sanadizal rights reserved iii d by IHS under lic se with ISt ed without license from IHS Not for Resale