ISO INTERNATIONAL STANDARD 3167 Fifth edition 2014-08-01 Plastics Multipurpose test specimens Plastigues - Eprouvettes a usages multiples Reference number ISO 3167:2014(E) ISO @ IS0 2014 IS0 3167:2014(E) COPYRIGHTPROTECTEDDOCUMENT ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISo copyright office Case postale 56 · CH-1211 Geneva 20 Tel.+41227490111 Fax +41 22 749 09 47 E-mail [email protected] Web:www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved IS0 3167:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 1 3 Dimensions oftest specimens ..1 4 Preparation of test specimen .2 4.1 General. .2 4.2 Injection moulding of multipurpose test specimens .3 4.3 Compression moulding of multipurpose test specimens 3 4.4 Machining of multipurpose test specimens .3 5 Report on preparation oftest specimens .3 Annex A (informative) Recommended applications for multipurpose test specimens or parts thereof ..5 Annex B (informative) Consequences of changes in geometry .6 Bibliography ..8 snQ4l rights reserved iii