ISO INTERNATIONAL STANDARD 3286 Second edition 2016-03-01 Single point cutting tools Corner radii Outils de coupe a partie active unique - Rayons de pointe Reference number A ISO 3286:2016(E) ISO International Organization for Standardization =ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 Not for Resale, 2016/4/26 02:48:33 itted without license from IHS IS0 3286:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Intenatinair brganizationfor Standardization ensee-ZHEJIANG INST.OF STANDARDIzARoISQ16- All rights reserved networking permitted without license from IHS IS0 3286:2016(E) Contents Page Foreword ..iv 1 Scope. .1 2 Dimensions. 3 Tolerances Annex A (informative) Relationship between designations in this International Standard and IS0 13399 .2 Bibliography .3 Inteatinal oganzation @st(Sar.2.a.1.6 - ll ights reserved iii ISee=ZHEJIANG INSTOF STANDARDIZATION C1 5956617 vided by IHS under ted withoutlicensefrom IHS