ISO/IEC INTERNATIONAL STANDARD 11695-1 Second edition 2015-05-15 Identification cards Optical memory cards Holographic recording method - Part 1: Physical characteristics Cartes d'identification - Cartes a mémoire optique - Méthode d'enregistrementholographique Partie 1: Caractéristiques physiques Reference number ISO/IEC11695-1:2015(E) Ts E( . International Organization for Standardization Institute of Standardization 5956617 @IS0/IEC 2015 itted without license from IHS IS0/IEC 11695-1:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS0/IEC 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 · CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Internationai ibr DrganizationforStandardization Not for Resale, 2015/8/7 05:24:52 networking permited withoutlicense from IHS IS0/IEC 11695-1:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. 2 Normative references 3 Terms and definitions ..1 4 Holographic Memory Cards - Physical Characteristics .3 4.1 Dimensions 3 4.1.1 Card height and width 3 4.1.2 Card thickness.. 3 4.1.3 Card corners .3 4.1.4 Card edges. 3 4.2 Construction .3 4.2.1 Card construction. 3 4.2.2 Cross-section at accessible optical area .3 4.3 Physical characteristics 3 4.3.1 Protective layer(s) 3 4.3.2 Storagelayer .4 4.3.3 Reflective layer .4 4.3.4 Substrate layer ..4 4.3.5 Additions. 4 4.3.6 Bending stiffness .5 4.3.7 Card warpage 5 4.3.8 X-rays. .5 4.3.9 Toxicity 5 4.3.10 Ultraviolet light. 5 4.3.11 Light transmittance 5 4.3.12 Bending properties. 5 4.3.13 Resistance to chemicals .5 4.3.14 Atmospheric requirements 5 4.3.15 .5 Durability 4.3.16 Dimensional stability and warpage with temperature and humidity 5 4.3.17 Default test environment and conditioning. .5 Annex A (informative) Holographic Data Storage. .6 Bibliography .10 iii icensee=Zhejiang Institute of Standardization 5956617 vided by IHS under lic ed without license from IHS Not for Resale, 2015/8/7 05:24:52