ISO INTERNATIONAL STANDARD 11148-1 First edition 2011-12-01 Hand-held non-electric power tools - Safety requirements - Part 1: Assembly power tools for non-threaded mechanical fasteners Machines portatives a moteur non électrique - Exigences de securite Partie 1: Machines portatives de pose d'elements de fixation non filetes Reference number ISO 11148-1:2011(E) ISO 2011 HS under ted without license from IHS Not for Resale ISO 11148-1:2011(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IsO 2011 - All rights reserved py IHS unde ermitted without license from IHS Not for Resale ISO 11148-1:2011(E) Contents Page Foreword .iv Introduction 1 Scope 2 Normative references.. 3 Terms and definitions .. 3.1 General terms and definitions... 3.2 Terms and definitions related to assembly power tools for non-threaded mechanical fasteners...... 4 Safety requirements and/or protective measures....... 4.1 General... 4.2 Mechanical safety... 4.3 Thermal safety ..... 4.4 Noise reduction 4.5 Vibration. 4.6 Materialsandsubstancesprocessed,usedorexhausted. 4.7 Ergonomics 4.8 Controls... Verification. 5.1 General conditions for the tests . 5.2 5.3 Vibration... 5.4 Unintentional start 5.5 Power tool construction 5.6 Structure of verification.. 8 6 Informationforuse 6.1 Marking, signs and written warnings ... .9 6.2 Instruction handbook.. 10 6.3 Operating instructions ... 14 6.4 6.5 Maintenance instructions . .15 Annex A (informative) List of significant hazards . ...16 Annex B (informative) Examples of assembly power tools for non-threaded mechanical fasteners covered by this part of Iso 11148..... 17 Annex C (normative) Symbols for labels and signs.. ..18 Bibliography 19 Copyright Inteatinal organizaionfar Standardizalion ghts reserved ili Not for Resale