ISO INTERNATIONAL STANDARD 1268-1 First edition 2001-12-01 Fibre-reinforced plastics Methods of producing test plates - Part 1: General conditions Plastiques renforcés de fibres - Methodes de fabrication de plaques d'essai- Partie 1: Conditions generales Reference number ISO 1268-1:2001(E) ISO @ISO2001 IHSunder Not for Resale ISO 1268-1:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event ?ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISO 2001 - All rights reserved itted without license from IHS Not for Resale ISO 1268-1:2001(E) Contents Page Foreword. i 1 Scope 2 Normative references. 3 Terms and definitions .. 4 Health and safety... 5 Principle.... 6 Raw materials and semi-finished products 7 Plate dimensions. 8 Reinforcement.. 6 General requirements for the laboratory/workshop apparatus 10 Procedure. 11 Verification of the characteristics of the plates obtained 12 Marking .. 13 Test plate preparation report.... ii HS under from IHS Not for Resale