ISO INTERNATIONAL STANDARD 13064-2 First edition 2012-09-15 Battery-electric mopeds and motorcycles Performance Part 2: Road operating characteristics Cyclomoteurs et motocycles électriques - Performance - Partie 2: Caractéristiques d'utilisation sur route Reference number IS0 13064-2:2012(E) LSO IS02012 HS under ted without license from IHS Not for Resale IS0 13064-2:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO 2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the addressbeloworIso'smemberbodyinthecountryoftherequester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel.+41227490111 Fax +41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2012 - All rights reserved Not for Resale IS0 13064-2:2012(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Principle 5 Parameters, units and accuracy of measurements ..2 6 Test conditions. .3 6.1 Vehicle conditions .3 6.2 Atmospheric conditions .3 6.3 Track conditions .3 6.4 Rider and riding position ..4 6.5 Driving selection mode. ..5 7 Preconditioning of the vehicle .5 Battery charge .5 7.1 7.2 Warm-up. .5 8 Test sequence. .5 9 Test procedures. ..6 9.1 Range at 80 % maximum speed 9.2 Complete battery discharge .6 9.3 Maximum speed. ..6 9.4 Partial battery discharge .7 9.5 Acceleration ability ..8 9.6 Hill starting ability ..8 9.7 Speed uphill .9 10 Presentation ofresults ..9 Annex A (informative) Specimen format for test result sheet .10 iii d by IHS under lic ense with ISt ithout license from IHS Not for Resale