ISO INTERNATIONAL STANDARD 13207-1 First edition 2012-02-15 Road vehicles LED lamp characteristics for bulb compatible failure detection - Part 1: LED lamps used as direction indicators Véhicules routiersCaractéristiques des lampes LED pour détection de défaut compatible avecI'ampoule Partie 1: Lampes LED utilisées comme feux indicateurs de direction Reference number ISO 13207-1:2012(E) ISO @IS02012 ISO 13207-1:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO 2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO2012-All rights reserved ISO 13207-1:2012(E) Foreword (isO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsoO shall not be held responsible for identifying any or all such patent rights. ISO 13207-1 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 3, Electrical and electronic equipment. ISO 13207 consists of the following parts, under the general title Road vehicles —LED lamp characteristics for bulb compatible failure detection: Part 1:LEDlamps used as direction indicators ii