ISO INTERNATIONAL STANDARD 13564-1 First edition 2012-09-15 Powered industrial trucks Test methods for verification of visibility Part 1: Sit-on and stand-on operator trucks and variable-reach trucks up to and including 10 t capacity Chariots de manutention automoteurs - Methodes d'essai pour la vérification de la visibilité- Partie 1: Chariots a conducteur assis et debout et chariots a portée variable ayant une capacité allant jusqu'a 10 t incluses Reference number ISO 13564-1:2012(E) @ ISO 2012 THS unde Not for Resale ISO 13564-1:2012(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or isO's memberbody inthe country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO 2012-All rights reserved itted without license from IHS Not for Resale ISO 13564-1:2012(E) Contents Page Foreword .iv 1 Scope 2 Normative references 3 Terms and definitions. 4 Truck configuration. 4.1 Testing.. 4.2 Height of load-carrying surface . 4.3 Tilt of the mast or load-carrying surface..... 4.4 Retractable mast trucks.... 5 Test equipment Direct visibility.... 5.1 Test body..... 5.2 5.3 Distance of the lighting equipment to the industrial truck.. 6 Test procedures Direct visibility 6.1 Light source position... 6.2 Test paths.... 6.3 Measurement procedure 7 Test procedures - - Indirect visibility .8 8 Other test methods. .8 9 Acceptance criteria .8 9.1 General 9.2 Direct visibility 8 9.3 Indirect visibility 9 10 Test report 10 10.1 Truck information 10.2 Test results .10 Bibliography 21 Copyright International Organization for Standardizalon ghts reserved ii se from IHS Not for Resale