ISO INTERNATIONAL STANDARD 13953 First edition 2001-09-15 Polyethylene (PE) pipes and fittings - Determination of the tensile strength and failure mode of test pieces from a butt-fused joint Tubes et raccords en polyéthylene (PE)Détermination de la résistance en traction et du mode de rupture d'éprouvettes prélevées dans des assemblages par soudage bout a bout Reference number ISO 13953:2001(E) Tso @ ISO 2001 Copyright International Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO13953:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, elec- tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's mem- ber body in the country of the requester. ISO copyright office Casepostale 56·CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland yationalganzaiSandardizatio @ ISO 2001 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 13953:2001(E) Contents Page 1 Scope 1 Normative reference 1 3 Principle 4 Apparatus 1 5 Testpieces 2 6 Conditioning 4 7 Procedure 4 8 Test report 5 Copyright International Organizatinfor Standagdizationserved ili No reproduction or networking permitted without license from IHS Not for Resale

.pdf文档 ISO 13953 2001 Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint

文档预览
中文文档 11 页 50 下载 1000 浏览 0 评论 309 收藏 3.0分
温馨提示:本文档共11页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
ISO 13953 2001 Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint 第 1 页 ISO 13953 2001 Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint 第 2 页 ISO 13953 2001 Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint 第 3 页
下载文档到电脑,方便使用
本文档由 人生无常 于 2024-08-31 10:51:01上传分享
站内资源均来自网友分享或网络收集整理,若无意中侵犯到您的权利,敬请联系我们微信(点击查看客服),我们将及时删除相关资源。