ISO INTERNATIONAL STANDARD 14159 First edition 2002-04-01 Safety of machinery - Hygiene requirements for the design of machinery Sécurite des machines - Prescriptions relatives a I'hygiene lors de la conception des machines Reference number ISO 14159:2002(E) So @ ISO 2002 ISO14159:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the.country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISO 2002 - All rights reserved ISO14159:2002(E) Contents Page Foreword.. iv Introduction 1 Scope 2 Normative references 3 Termsand definitions 4 Hazards. 5 Hygiene requirements and/or measures.. 5.1 Strategy for selecting hygiene measures 5.2 Hygienic design .. 6 Verification of hygiene measures and test methods . 11 7 Instruction handbook, maintenance and cleaning... 7.1 Instruction handbook... 7.2 Maintenance and cleaning ..... Additional information (limitations of use).. 8 Annex A (informative) Categorization of machinery and associated equipment for intended use... Annex B (informative) Examples of good and bad hygienic design features. Annex C (informative) Relationship between International Standards referenced in clause 2 and corresponding European Standards ... Bibliography. served ii