ISO INTERNATIONAL STANDARD 14617-5 First edition 2002-09-01 Corrected version 2003-08-01 Graphical symbols for diagrams - Part 5: Measurement and control devices Symboles graphiques pour schemas- Partie 5: Dispositifs de mesure et appareils de commande Reference number ISO 14617-5:2002(E) @ISO 2002 Copyright International Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 14617-5:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this fle may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ iS0 2002 - All rights reserved CopyihtIntenatinal organizatin for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 14617-5:2002(E) Contents Page Foreword Introduction 1 Scope... 2 Normative references.. 3 Terms and definitions.. 4 Sensors, signal converters and measuring transducers... 5 Fittings for sensors and measuring transducers .... 6 Measuring transducers of transformer type.... 7 Measuring and related instruments 8 Counting devices and clocks.. 9 Displays. 10 Signalling devices 12 11 Binary logic elements ...... 13 12 Devices for analogue signal processing Bibliography... @IsO2002-All rights reserved ili Copyright Intermational Organization for Standardization uction or networking permitted without license from IHS Not for Resale