ISO INTERNATIONAL STANDARD 14648-1 First edition 2001-12-01 Micrographics Quality control of coM recorders that generate images using a single internal display system Part 1: Characteristics of the software test target Micrographie - Controle de la qualite des microformes produites sur un systeme électronique (COM) de génération d'image adressage de points- Partie 1: Caracteristiques de la cible controle de la qualité Reference number ISO 14648-1:2001(E) ISO @ ISO 2001 Not for Resale ISO 14648-1:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2001 - All rights reserved py IHS unde ermittedwithout license from IHS Not for Resale ISO 14648-1:2001(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(iSC Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Attention is drawn to the possibility that some of the elements of this part of IsO 14648 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 14648-1 was prepared by Technical Committee ISO/TC 171, Document imaging applications, Subcommittee Sc 1, Quality. IsO 14648 consists of the following parts, under the general title Micrographics - Quality control of COM recorders Part 1: Characteristics of the software test target Part2:Method ofuse ili