ISO INTERNATIONAL STANDARD 14649-14 First edition 2013-03-01 Automation systems and integration Physical device control Data model for computerized numerical controllers - Part 14: Process data for sink electrical discharge machining (sink-EDM) Systemes d'automatisation et integration - Commande des dispositifsphysiques-Modelede données pourles controleurs numeriques informatisés - Partie 14: Données de procédé pour I'usinage de baisse électrique (baisseEDM) Reference number X IS014649-14:2013(E) LSO @ IS0 2013 It license from IHS Not for Resale IS0 14649-14:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 14649-14:2013(E) Contents Page Foreword ..iv Introduction. 1 Scope.. 2 Normative references 3 Terms and definitions 4 Process data for sink-EDM ..2 4.1 Header and references .2 4.2 Manufacturing features for sink-EDM 4.3 Machining operation for sink-EDM ..3 Annex A (informative) EXPRESS listing .13 Annex B (informative) EXPRESS-G ..16 Bibliography .26 iii d by IHS under lic ense with ISt ed without license from IHS Not for Resale