ISO INTERNATIONAL STANDARD 15001 Second edition 2010-06-01 Anaesthetic and respiratory equipment Compatibility with oxygen Materiel d'anesthésie et de réanimation respiratoire - Compatibilite avecI'oxygene @ International Organization for Standardization (IsO), 2010. All rights reserved. NOT FOR RESALE. Reference number ISO 15001:2010(E) SO @ ISO 2010 ISO 15001:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation COPYRIGHTPROTECTEDDOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 :CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org ii CAN/CSA-Z15001:12 @ ISO 2010 - All rights reserved ISO 15001:2010(E) Contents Page Foreword. .iv Introduction 1* Scope 2 Normativereferences. 3 Termsanddefinitions 4 Cleanliness. 5* Resistance to ignition 6 Risk management... Annex A (informative) Examples of cleaning procedures .. Annex B (informative) Typical methods for validation of cleaning procedures.. 11 AnnexC(informative)Designconsiderations.. ..14 Annex D (informative) Selection of materials.... ..19 Annex E (informative) Recommended method for combustion and quantitative analysis of combustionproductsof non-metallicmaterials....... Annex F (informative) Rationale.... .37 sISO2010-All rightsreserved CAN/CSA-Z15001:12 il e from IHS a/5911922001