ISO INTERNATIONAL STANDARD 15027-1 Second edition 2012-11-01 Immersion suits- Part 1: Constant wear suits, requirements including safety Combinaisons deprotection thermiqueen cas d'immersion- Partie 1: Combinaisons de port permanent, exigences y compris la securite Reference number ISO 15027-1:2012(E) ISO @ ISO 2012 py IHS under lic Not for Res 001, User=sharabiani, shahramfs ted without license from IHS ISO 15027-1:2012(E) COPYRIGHT PROTECTED DOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56·CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ISO 2012 - All rights reserved y IHS unde nsee=University of Alberta/5966844001, User=sharabiani, shahramfs etworking permitted without license from IHS ISO 15027-1:2012(E) Contents Page Foreword .iv Introduction 1 Scope 2 Normative references 3 Terms and definitions 2 4 Requirements 4.1 General. 4 4.2 Basic health and ergonomic requirements 5 4.3 Gas or air inflation.. 4.4 Buddy lines 6 4.5 Conspicuity 4.6 Foam flotation material 8 4.7 Flammability 8 4.8 Temperature cycling 8 4.9 Leakage...... 8 4.10 Thermal protection in water 8 4.11 Performance requirements... 4.12 Requirements on materials,fabrics and components 10 5 Marking, 12 6 Information supplied by the manufacturer. .13 7 Consumer information at point of sale. 7.1 Data list.... 7.2 Consumer information label.. ..13 Annex A (informative) Guidelines for manufacturers, users, regulators and industrial inspectors about immersionsuitswithrespecttotheapplicationofthermalprotectiontimesrelevanttothe ISO 15027 series.... .15 Bibliography 18 ili ut license from IHS Not for