ISO INTERNATIONAL STANDARD 15086-1 First edition 2001-10-01 Hydraulic fluid power Determination of fluid-borne noise characteristics of components and systems Part 1: Introduction Transmissions hydrauliques — Evaluation des caractéristiques du bruit liquidien des composants et systemes- Partie 1: Introduction Reference number A ISO 15086-1:2001(E) ISO @ ISO 2001 y IHS under ted without license from IHS Not for Resale ISO 15086-1:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @Io2001-All rights reserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 15086-1:2001(E) Contents Page Foreword.. .iv Introduction. 1 Scope .. 2 Normative reference.. 1 Terms and definitions ... 1 4 Symbols.. Basic considerations.. 6 Practical aspects Bibliography.. .11 CopyrighIntemaganzanforSdadizaioed ili d by IHS under license with thout license from IHS Not for Resale