ISO INTERNATIONAL STANDARD 15785 First edition 2002-07-01 Technical drawings Symbolic presentation and indication of adhesive. fold and pressed joints Dessins techniques - Représentation symbolique et indication des assemblages collés, repliés et clinchés Reference number ISO 15785:2002(E) ISO @ ISO 2002 IHSunder ISO15785:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event ?ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland ISO 2002 - All rights reserved 1/9972545001 ermitted without license from IHS ISO 15785:2002(E) Contents Page Foreword. .iv 1 Scope 1 2 Normative references. 3 Terms and definitions. 4 Graphical symbols.. 5 Indication of joints in drawings.... 3 9 Basic conventions for symbolic presentation and indication of joints. Designation examples... Annex A (normative) Presentation and dimensions of graphical symbols .. ili IHS under li from IHS