ISO INTERNATIONAL STANDARD 16119-2 First edition 2013-03-01 Agricultural and forestry machinery Environmental requirements for sprayers Part 2: Horizontal boom sprayers Matériel agricole et forestier - Exigences environnementales pour les pulverisateurs Partie 2: Pulvérisateurs a rampe horizontale Reference number ISO 16119-2:2013(E) LSO @ IS0 2013 I without license from IHS Not for Resale IS0 16119-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 16119-2:2013(E) Contents Page Foreword ..iv Introduction. 1 Scope 2 Normative references 3 Terms and definitions 4 List of significant hazards 2 5 Requirements .3 5.1 General 3 5.2 Volume/hectare adjustment system .9 5.3 Distribution and control of spray drift .9 5.4 Cleaning.... .10 5.5 Cleaning devices . .11 5.6 Additional requirements for band sprayers 11 5.7 Additional requirements for spray guns and lances .12 6 Verification ..12 7 Marking. ..13 8 Instruction handbook ..13 Bibliography .14 iii ded by IHS under lic cense with ISt ed without license from IHS Not for Resale