ISO INTERNATIONAL STANDARD 16145-1 First edition 2012-10-01 Ships and marine technology Protective coatings and inspection method - Part 1: Dedicated sea water ballast tanks Navires et technologie maritime Revetements de protection et méthode d'inspection- Partie1:Ballastsd'eaudemerdédiee Reference number ISO 16145-1:2012(E) ISO Copyright intematioal Organizatin for Standardizatin @ISO2012 HS under I No reproduction or networking permitted without license from IHS Not for Resale ISO 16145-1:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail
[email protected] Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale ISO 16145-1:2012(E) Contents Page Foreword ..iv Introduction 1 Scope 2 Normative references 2 3 Terms and definitions. ..3 4 Symbols and abbreviated terms 4.1 Symbols.... 4.2 Abbreviated terms.. 5 General procedures for coating work.. 6 Standard for coating work .. 6 6.1 Surface preparation .. 6 6.2 Primary surface preparation and shop priming 6.3 Secondary surface preparation.. 6.4 Coating..... 10 6.5 Treatment for coating defects. 13 7 Inspection.. 14 7.1 Inspection procedure 14 7.2 Coating inspection.. 14 7.3 Dry film thickness measurement 16 Annex A (informative) Measurement of the conductivity for abrasives. 21 Annex B (informative) Measurement of water soluble salt. .23 Annex C (informative) Inspection items and management of inspection .25 Annex D (informative) Assessment for the degree of damage... .30 Annex E (informative) Standard for coating technical file (CTF). .31 Bibliography 40 ili t license from IHS Not for Resale
ISO 16145-1 2012 Ships and marine technology — Protective coatings and inspection method — Part 1 Dedicated sea water ballast tanks
文档预览
中文文档
49 页
50 下载
1000 浏览
0 评论
309 收藏
3.0分
温馨提示:本文档共49页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
本文档由 人生无常 于 2024-08-31 11:48:33上传分享