ISO INTERNATIONAL STANDARD 16635-1 Firstedition 2013-04-01 Dentistry Dental rubber dam technique - Part 1: Hole punch Médecine bucco-dentaire - Technique de la digue dentaire en caoutchouc- Partie1:Pinces apercerla digue Reference number ISO 16635-1:2013(E) ISO Copyright Intermational Organization for Standardization @IS02013 No reproduct Not for Resale IS0 16635-1:2013(E) COPYRIGHTPROTECTEDDOCUMENT @IS02013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form orby any means,electronic or mechanical, including photocopying,or posting on the internet or an intranet, withoutprior writtenpermission.Permission canbe requested from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel.+4122 7490111 Fax+41227490947 E-mail [email protected] Web www.iso.org Published in Switzerland Copyrighematinai oganizatinfor Standadizatin ISo2013-Allrights reserved No reproductionornetworking permited without iense from IHs Not for Resale IS0 16635-1:2013(E) Contents Page Foreword ..iv Introduction. .. 1 Scope. .1 2 Normative references .1 3 Terms and definitions 1 4 Requirements .2 4.1 General 2 4.2 Total length 2 4.3 Distance between the forceps handles in the open passive state 2 4.4 Characteristics of the die plate .3 4.5 Distances 3 4.6 Spring type mechanism. 4.7 Materials 4 4.8 Surface profile and finish 4 5 Test methods. .4 5.1 Visual examination 4 5.2 Dimensions 4 6 Marking. 4 Copyright Intermational Organization for standardization - All rights reserved iii No reproduct ction or networking permited withoutlicense from IHS Not for Resale