ISO INTERNATIONAL STANDARD 18436-5 First edition 2012-11-01 Condition monitoring and diagnostics of machines Requirements for qualification and assessment of personnel- Part 5: Lubricant laboratory technician/analyst Surveillance et diagnostic d'état des machines - Exigences relatives a la qualification et a I'évaluation du personnel- Partie 5: Technicien/analyste de laboratoire d'analyse de lubrifiants Reference number ISO 18436-5:2012(E) LSO @ ISO 2012 I without license from IHS Not for Resale ISO18436-5:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2012 -All rights reserved No reproductic etworking permitted without license from IHS Not for Resale ISO 18436-5:2012(E) Contents Page Foreword ..iv Introduction 1 Scope 2 Normative references 3 Termsanddefinitions. .3 4 Classification of personnel (laboratory lubricant analysis). 3 4.1 General 3 4.2 Category ! 4.3 Category II 4.4 Category III 5 Eligibility 5 5.1 General, 5 5.2 Education. 5 5.3 Training 5.4 Experience. 5 6 Examinations. 6 6.1 Examinationcontent. 6 6.2 Conductof examinations Annex A (normative) Training course requirements for laboratory lubricant analysis personnel.. Bibliography ili e with I license from IHS Not for Resale