ISO INTERNATIONAL STANDARD 2010 Fourth edition 2011-09-01 Slotted raised countersunk head screws Product grade A Vis a métaux a tete fraisée bombée fendue - Grade A Reference number ISO 2010:2011(E) @ ISO 2011 ISO 2010:2011(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 2010 was prepared by Technical Committee ISO/TC 2, Fasteners, Subcommittee SC 11, Fasteners with metric external thread. This fourth edition cancels and replaces the third edition (isO 2010:1994), of which it constitutes a minor revision. @ ISO 2011 - All rights reserved ili ISO 2010:2011(E) INTERNATIONALSTANDARD Slotted raised countersunk head screws Product grade A Scope This International Standard specifies the characteristics of countersunk slotted raised head screws of product grade A and with threads from M1,6 to M10 inclusive. be selected from existing International Standards, for example ISO 261, ISO 888, IsO 898-1, ISO 965-2 and ISO3506-1. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Iso 225, FastenersBolts, screws, studs and nuts-Symbols and descriptions of dimensions IsO 261, /sO general purpose metric screw threads- General plan Iso 898-1, Mechanical properties of fasteners made of carbon steel and alloy steel - Part 1: Bolts, screws and studs with specified property classes - Coarse thread and fine pitch thread purposeexternaland internalscrewthreads-Mediumquality IsO 3269, Fasteners —Acceptance inspection IsO 3506-1, Mechanical properties of corrosion-resistant stainless steel fasteners - Part 1: Bolts, screws and studs ISO 4042, Fasteners —Electroplated coatings IsO 4759-1, Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts Product grades A, B and C Iso 6157-1, Fasteners — Surface discontinuities — Part 1: Bolts, screws and studs for general requirements Iso 8839, Mechanical properties of fastenersBolts, screws, studs and nuts made of non-ferrous metals IsO 8992, Fasteners General requirements for bolts, screws, studs and nuts Iso 10683, Fasteners -Non-electrolytically applied zinc flake coatings IsO 16048, Passivation of corrosion-resistant stainless-steel fasteners @ ISO 2011 - All rights reserved