ISO INTERNATIONAL STANDARD 20152-1 First edition 2010-08-01 Timber structures Bond performance of adhesives - Part 1: Basic requirements Structures en bois Performance d'adhérence des adhésifs Partie 1: Exigences de base Reference number ISO 20152-1:2010(E) @ ISO 2010 Provided by IHS se from IHS Not for Resale ISO 20152-1:2010(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHT PROTECTED DOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2010 - Allrights reserved Provided by IHS Not for Resale ISO 20152-1:2010(E) Contents Page Foreword Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Application 5 Requirements.... 5.1 Adhesive details, mixing and application . 5.2 Anti-fungal properties ... 5.3 Acid damage to wood fibre... 5.4 Shear strength and wood failure 5.5 Delamination resistance ... 5.6 Creep resistance.. 6 Sample preparation and test methods .. 6.1 Anti-fungal properties.. 6.2 Acid damage to wood fibre. 6.3 Specimen requirements.. 6.4 Wood moisture content .... 6.5 Sheartest and woodfailure assessment. 6.6 Delamination resistance test... 6.7 Creep resistancetest. 12 7 Adhesive sample 2 8 Rejection. 22 9 Reporting 22 9.1 9.2 Product description.. 22 9.3 Specimen preparation and testing 23 9.4 Test results ..... 24 Annex A (normative) Interrupting the boil-dry-freeze conditioning. 25 AnnexB(normative)Measurementandcomputationofbondlinecreepforenvironmentaltest conditions A, B and C 26 Bibliography.... Iso 2010 -All rights reserved ii Provided by IHS nitted without license from IHS Not for Resale