ISO INTERNATIONAL STANDARD 2230 Second edition 2002-04-15 Rubber products Guidelines for storage Produits a base d'élastomeres - Lignes directrices pour le stockage Reference number ISO 2230:2002(E) ISO @ ISO 2002 ISO 2230:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, memberbody in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii @ ISO 2002 - All rights reserved ISO 2230:2002(E) Contents Page Scope 2 Normative references 3 Terms anddefinitions Classification of rubber types according to their relative susceptibility to deterioration 2 5 Packaging .. 4 Storage ... 5 7 Inspection, testing and recording of data during storage . Annex A Recommendations for inspection and testing of specific products 10 Bibliography.. 11 @ISO2002-Allrightsreserved ii