ISO INTERNATIONAL STANDARD 22654 First edition 2002-06-15 Footwear Test methods for outsoles Tensile strength and elongation Chaussures Methodes d'essai applicables aux semelles d'usure - Résistance a la traction et a I'allongement Reference number ISO 22654:2002(E) ISO @ ISO 2002 Copyright International Organization for Standardization Not for Resale ISO22654:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland yemainagazaiandardizato @ISO2002-All rights reserved mittedwithoutlicense from IHS Not for Resale ISO 22654:2002(E) Foreword liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. IS0 22654 was prepared by CEN (as EN 12803:2000) and was adopted, under a special "fast-track procedure", by Technical Committee ISO/TC 216, Footwear, in parallel with its approval by the ISO member bodies. For the purposes of international standardization, a list of corresponding International and European Standards for which equivalents are not given in EN 12803 has been added as Annex ZZ. The version of EN 12803 reproduced in this International Standard incorporates the corrigendum EN 12803:2000/AC:2002. ii