ISO INTERNATIONAL STANDARD 5599-2 Second edition 2001-09-01 AMENDMENT 1 2004-08-15 Pneumatic fluid power Five-port directional control valves - Part 2: Mounting interface surfaces with optional electrical connector AMENDMENT 1 Transmissions pneumatiquesDistributeurs a cinq orifices principaux- Partie 2: Plans de pose avec connecteur électrique facultatif AMENDEMENT1 Reference number ISO 5599-2:2001/Amd.1:2004(E) [So @ ISO 2004 No reproduction or networking permited without license from IHS Not for Resale SO5599-2:2001/Amd.1:2004(E) PDFdisclaimer shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer perfoming the editing. In accepts no liability in this area Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by Iso member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ ISO 2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any fom or by any means, iSO's memberbody in thecountry oftherequester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax+41227490947 E-mail [email protected] Web www.iso.org Published in Switzerland @IsO2004-All rights reserved dardization Reproduced by IHS under license with ISO Not for Resale ISO 5599-2:2001/Amd.1:2004(E) Foreword non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Amendment 1 to ISO 5599-2:2001 was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee Sc 5, Control products and components. tandardization'ghtsreserved ili Not for Resale