ISO INTERNATIONAL STANDARD 5608 Fourth edition 2012-08-15 Turning and copying tool holders and cartridges for indexable inserts Designation Porte-plaquette de tournage et de copiage et cartouches pour plaquettesamovibles-Désignation Reference number ISO 5608:2012(E) SO @ISO2012 No reproduction or networking permitted without license from IHS Not for Resale ISO5608:2012(E) COPYRIGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's memberbody in the country of therequester. ISO copyright office Case postale 56· CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2012 -All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 5608:2012(E) Contents Page Foreword ..iv 1 Scope 2 Explanationofthedesignationcode 2.1 General 2.2 Letterandnumbersymbolscomprisingthedesignationcode 3 Compulsorysymbols. 3.1 Symbolfortheholdingmethodofthehorizontallymounted insert Referenceposition (1). 2 3.2 Symbolforinsertshape-Referenceposition(2) 2 3.3 Symbol for tool styleReference position (3).. 3.4 SymbolfortheinsertnormalclearanceReferenceposition(4) 3.5 Symbolforhandoftool-Referenceposition5.. 5 3.6 Symbolfortoolheight-Referenceposition(6) 5 3.7 Symbolfortool width—Referenceposition (7).. 6 3.8 Symbol fortool lengthReferenceposition(8) 6 3.9 Symbolforindexableinsertsize-Referenceposition(9) 8 4 Optionalsymbol:symbolforspecialtolerances—Referenceposition(10) 8 Annex A (informative)Relationship between designations inthis International Standard and the ISO13399series 10 Bibliography 11 ili inse from IHS Not for Resale