ISO INTERNATIONAL STANDARD 5753-2 First edition 2010-12-15 Rolling bearings Internal clearance - Part 2: Axial internal clearance for four-point-contact ball bearings Roulements-Jeu interne- Partie 2: Jeu interne axial pour roulements a billes a quatre points de contact Reference number ISO 5753-2:2010(E) @ISO 2010 py IHS under ted without license from IHS Not for Resale ISO 5753-2:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In COPYRIGHT PROTECTED DOCUMENT @ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Copyrgh Interatinal organization for Standardization @ ISO 2010 - All rights reserved I without license from IHS Not for Resale ISO 5753-2:2010(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO 5753-2 was prepared by Technical Committee ISO/TC 4, Rolling bearings, Subcommittee SC 4. Tolerances. Iso 5753 consists of the following parts, under the general title Rolling bearings - Internal clearance: Part 1:Radial internal clearance for radial bearings -Part 2: Axial internal clearance for four-point-contact ball bearings ii